💕 DTF Transfer Pressing Instructions 🎀

🔥 Step 1: Preheat & Prep
Set heat press to 300–325°F. Pre-press garment for 7 seconds to remove moisture and wrinkles.

🎯 Step 2: Position
Place transfer design-side down on garment. Secure with heat-resistant tape if needed.

⏳ Step 3: Press
Cover with parchment paper or Teflon sheet, if recommended. Press for 7 seconds with medium to firm pressure.

💗 Step 4: Peel
Follow your transfer's peel instructions:

  • Hot Peel: Remove film immediately.

  • Cold Peel: Let cool completely before removing.

✨ Step 5: Final Press
Cover design and press again for 7 seconds for a smooth, lasting finish.

💕 Press • Peel • Wear • Repeat! 💕

Always follow your transfer supplier's specific pressing instructions, as settings may vary.


✨ Glitter DTF Transfer Pressing Instructions 🎀

🔥 Step 1: Preheat & Prep
Set heat press to 300°F. Pre-press garment for 10 seconds to remove moisture and wrinkles.

🎯 Step 2: Position
Place glitter DTF transfer design-side down on garment. Secure with heat-resistant tape if needed.

⏳ Step 3: Press
Press at 300°F for 10 seconds with medium to firm pressure (60–80 PSI on pneumatic presses).

💗 Step 4: Cold Peel
Allow transfer to cool completely before carefully peeling the film. Do NOT peel while warm!

✨ Step 5: Final Press
Cover design with parchment paper or a protective sheet and press again at 300°F for 10 seconds to seal.

💕 Press • Cool • Peel • Wear! 💕